Workrite Support Channels Manual de usuario descargar pdf

#1500127 - Rev B Workrite Ergonomics | 800.959.9675 www.workriteergo.com

#12 x ¾” Screws

Qty: 24 or 48

Support Channel

(length differs for each model)

Qty: 1 or 2

Parts by Carton

Assembly Instructions

for Support Channels

Attach Support Channel

If you have only one Support Channel, position it on the longer side of the worksurface,

approximately 4 inches from the back edge.

If you have two Support Channels, similarly position

the second one on the shorter (or other equal) side

of the worksurface, approximately 4 inches from the

back edge.

Be sure all cables between legs are within Channel

and are not trapped under Channel edge, then

attach Channels using screws provided.

Verify that you have all the hardware and tools needed for the assembly

You will also need:

#3 tip Phillips screwdriver or drill bit

If the Channel is being attached to the

side that contains the workcenter’s

control box, be sure to attach the

control box rst, as close to the back

edge of the worksurface as possible,

to allow room for the Channel.

#1500127 - Rev B Workrite Ergonomics | 800.959.9675 www.workriteergo.com B #12 x ¾” Screws Qty: 24 or 48A Support Channel (length differs for

Sin comentarios

Workrite Support Channels Manual de usuario